|By Testtaker (Testtaker) on Thursday, May 29, 2003 - 07:25 pm: Edit|
Sometimes I will do something on my calculator that is apparently a little complex for it to handle. In this case, it says busy in the lower right hand corner and won't let me do anything else. Usually this goes away relatively fast but a few times, the calculator has gotten stuck in this mode after which I had difficulty getting it back to normal. I am afraid something like this will happen to me on my SAT. Is there any key I can press or anything I can do to cancel a command that has this effect?
|By Montydsw11 (Montydsw11) on Thursday, May 29, 2003 - 07:27 pm: Edit|
just press on, this will break the loop it is running
Report an offensive message on this page E-mail this page to a friend
|Posting is currently disabled in this topic. Contact your discussion moderator for more information.|
|Administrator's Control Panel -- Board Moderators Only|